Hello,

is this the right place to post feature requests?

I have a new PlutoSky R2 (AD9361) and noticed that when switching between OpenWebRX profiles with different sample rates, the AD9361 rf_bandwidth setting does not change.

It would be useful to have an RF bandwidth setting per profile, similar to the sample rate setting.

For example:

• 1 MS/s profile → 1 MHz RF bandwidth
• 4 MS/s profile → 4 MHz RF bandwidth
• 10 MS/s profile → 10 MHz RF bandwidth

Currently, if rf_bandwidth is set to 1 MHz and I switch to a 4 MS/s profile, it remains at 1 MHz, so the analog RX bandwidth is much narrower than the sampled spectrum.

Ideally, the profile could contain a configurable rf_bandwidth value which is passed to SoapySDR using setBandwidth().

For example, on the AD9361 the current RX RF bandwidth can be read with:

iio_attr -u ip:192.168.20.70 -i -c ad9361-phy voltage0 rf_bandwidth

and it can be changed independently of the sample rate, for example:

iio_attr -u ip:192.168.20.70 -i -c ad9361-phy voltage0 rf_bandwidth 4000000

This would set the RF bandwidth to 4 MHz, which would be useful for an OpenWebRX profile using a 4 MS/s sample rate.

The AD9361 in my PlutoSky R2 supports RX RF bandwidth values up to 56 MHz.

Thanks!